30Cr13不锈钢冶炼过程夹杂物控制技术

  针对30Cr13生产过程中存在的轧材非金属夹杂物合格率偏低仅85%左右的问题，通过对30Cr13不锈钢精炼过程钢中非金属夹杂物存在形态进行分析，并结合现有精炼工艺制度，在实验室研究的基础上制定了不锈钢精炼过程非金属夹杂物控制方案。工业应用后，精炼结束钢中大于5 μm的非金属夹杂物总数、形状以及尺寸等参数均得到了有效改善，钢水洁净度大大提高。     

Multiphase topology optimization with a single variable using the phase-field design method

In this study, a multimaterial topology optimization method using a single variable is proposed by combining the solid isotropic material with penalization method and the reaction-diffusion equation. Unlike ordinary multimaterial optimization, which requires several variables depending on the number of material types, this method intends to represent various materials as one variable. The proposed method combines two special functions in the sensitivity analysis of the objective function to converge the design variable into prespecified density values defined for each of the multimaterials. The composition constraint based on a normal distribution function is also introduced to estimate the distribution of each target density value in a single variable. It enables density exchange between multiple materials by increasing or decreasing the amount of a specific material. The proposed method is applied to structural and electromagnetic problems to verify its effectiveness, and its usefulness is also confirmed from the viewpoint of cost and computation time.     

SiO2对CaO-Fe2O3熔体结晶矿物组成及显微结构的影响

摘要：由于近年来低品位铁矿石的使用量增加，导致烧结过程中SiO2含量升高。SiO2是烧结矿中主要的脉石成分，其含量的变化与烧结矿最终质量密切相关。运用X射线衍射、光学显微镜和SEM-EDS方法研究了SiO2对CaO-Fe2O3熔体结晶矿物组成及显微结构的影响。研究结果表明，随着SiO2含量的增加，CaO-Fe2O3-SiO2熔体结晶产物中CaFe2O4(CF)含量减少而富铁铁酸钙(SFC)含量增加，CaFe2O4和SFC分别以块状和板条状析出，SFC的晶体结构随着SiO2含量的增加从Ca36Fe144O25-2向SFCA-I转变；当SiO2的质量分数超过3.0%时，椭圆状的Ca2SiO4（C2S）从熔体中结晶，其含量随SiO2含量的增加而增加，另有大量圆点状玻璃相分布于铁酸钙基体表面。     

利用热解-气相色谱/质谱联用仪研究减压渣油及其胶质亚组分的热解规律

以长庆减压渣油及其胶质亚组分为原料，利用热解-气相色谱/质谱联用仪对其在不同条件下热解的产物进行分析，考察反应温度和升温速率对减压渣油热解的影响。结果表明：随着反应温度升高，热解产物中低碳烯烃含量增加，汽柴油馏分含量先增加后减小，在700 ℃ 时达到峰值；升温速率为1℃/ms时，汽柴油馏分含量最高；芳碳率越大、缩合程度越高的重胶质裂解能力越差。     

电化学反应器隔膜材料的分子设计与介尺度策略

电化学反应器中隔膜材料是将正极和负极在电子通路上隔开但在离子传输通路上保持畅通的特殊材料。作为电化学反应器三个关键材料之一，隔膜材料还需耐强酸/强碱和高电压等环境。围绕电化学反应器中隔膜材料，从分子设计的角度针对材料电化学性能与化学稳定性的调控、电化学装置的介观传质性能的促进和改善等研究思路与进展进行了综述，为相关研究提供性能导向的分子设计参考。     

不同产地及成熟度牛油果及其油脂品质比较

分析不同产地及成熟度牛油果及其油脂理化性质,脂肪酸组成及反式脂肪酸组成。结果表明:牛油果作为水果,粗脂肪含量和粗蛋白质含量很高;不同产地及成熟度牛油果溶剂提取所得油脂理化性质和脂肪酸组成有一定的差异。研究可为进一步开发牛油果油和制定牛油果油标准提供参考。     

In Silico Study on Tumor-Size-Dependent Thermal Profiles inside an Anthropomorphic Female Breast Phantom Subjected to Multi-Dipole Antenna Array

Electromagnetic hyperthermia as a potent adjuvant for conventional cancer therapies can be considered valuable in modern oncology, as its task is to thermally destroy cancer cells exposed to high-frequency electromagnetic fields. Hyperthermia treatment planning based on computer in silico simulations has the potential to improve the localized heating of breast tissues through the use of the phased-array dipole applicators. Herein, we intended to improve our understanding of temperature estimation in an anatomically accurate female breast phantom embedded with a tumor, particularly when it is exposed to an eight-element dipole antenna matrix surrounding the breast tissues. The Maxwell equations coupled with the modified Pennes’ bioheat equation was solved in the modelled breast tissues using the finite-difference time-domain (FDTD) engine. The microwave (MW) applicators around the object were modelled with shortened half-wavelength dipole antennas operating at the same 1 GHz frequency, but with different input power and phases for the dipole sources. The total input power of an eight-dipole antenna matrix was set at 8 W so that the temperature in the breast tumor did not exceed 42 °C. Finding the optimal setting for each dipole antenna from the matrix was our primary objective. Such a procedure should form the basis of any successful hyperthermia treatment planning. We applied the algorithm of multi for multi-objective optimization for the power and phases for the dipole sources in terms of maximizing the specific absorption rate (SAR) parameter inside the breast tumor while minimizing this parameter in the healthy tissues. Electro-thermal simulations were performed for tumors of different radii to confirm the reliable operation of the given optimization procedure. In the next step, thermal profiles for tumors of various sizes were calculated for the optimal parameters of dipole sources. The computed results showed that larger tumors heated better than smaller tumors; however, the procedure worked well regardless of the tumor size. This verifies the effectiveness of the applied optimization method, regardless of the various stages of breast tumor development.     

Research on Circular Area Search algorithm of multi-robot service based on SOA cloud platform

Considering autonomous mobile robots with a variety of specific functions as a kind of service, when there are many types and quantities of services and the density of regional services is large, proposing an algorithm of Circular Area Search (CAS) because of the problem of multi-robot service scheduling in various areas. Firstly, Django is used as the web framework to build the Service-Oriented Architecture (SOA) multi-robot service cloud platform, which is the basic platform for multi-service combination. Then, the service type, the latitude and longitude and the scoring parameters of the service are selected as the service search metrics to design the CAS algorithm that based on the existing service information registered in MySQL and the Gaode Map for screening optimal service, and then providing the service applicant with the best service. Finally, the service applicant applies for the self-driving tour service as an example to perform performance simulation test on the proposed CAS algorithm. The results show that the CAS algorithm of the multi-robot service cloud platform proposed in this paper is practical compared to the global search. And compared with the Greedy Algorithm experiment, the service search time is reduced about 58% compared with the Greedy Algorithm, which verifies the efficiency of CAS algorithm.     

Comparative study of the phenolics,antioxidant and metagenomic composition of novel soy whey-based beverages produced using three different water kefir microbiota

Water kefir microbiota was used to develop novel soy whey-based beverages that have antioxidant activity. In the present study, comparative phenolics, antioxidant and metagenomic composition of the soy whey beverages fermented using three different water kefir microbiota, named WKFS-A, WKFS-B and WKFS-C were investigated. WKFS-B beverage had the highest concentrations of isoflavone aglycones (208.73 ± 2.78 mg L⁻¹) and phenolic acids (132.33 ± 3.41 mg L⁻¹) compared with WKFS-A (193.88 ± 1.15 mg L⁻¹) and (91.73 ± 2.34 mg L⁻¹) and WKFS-C (160.63 ± 1.76 mg L⁻¹) and (97.13 ± 2.63 mg L⁻¹), respectively. The WKFS-B also showed higher DPPH and ABTS radical scavenging activity and ferric reducing antioxidant power compared with WKFS-A and WKFS-C beverages. Microbial species diversity index analysis showed that a higher concentration of isoflavone aglycones, phenolic acids and increased antioxidant activity in the WKFS-B beverage correlates with the higher relative abundance of Lactobacillus genus. This study thus revealed that Lactobacillus dominated water kefir microbiota produces soy whey beverages with high phenolic acids, isoflavone aglycones and antioxidant activity.